KilnTech Episode 12: Replacing the RTD Sensor Hey guys, We heard you were ready for another episode of KilnTech, so here it is! In this episode of KilnTech, Stan and Mitch are here with one of our most requested videos! In this episode, they will be showing you how to properly replace your RTD sensor....
Read More

KilnTech Episode 11: L200 Error Message We are pumped to give you another episode of KilnTech! In Episode 11 Stan is going to cover one of the simple error messages that he sometimes gets calls about. Give it a watch and remember if you have questions or topics that you'd like to see discussed in...
Read More

KilnTech Episode 10: High-Pressure switch reset for L53/L200 Woohoo, it's our First episode of KilnTech for 2021! In this Episode, Stan will be covering how to reset the High-pressure switch for the L53 and L200 drying units! Don't forget to let us know what you'd like to see on an upcoming episode of KilnTech! email...
Read More

KilnTech Episode 9: L53/L200 Drain Line Installation We couldn't let 2020 end without one more episode of KilnTech. In this episode, Stan discusses how to properly install the drain line on our L53/L200 drying units. Don't forget to let us know what you'd like to see discussed in our next episode of Kilntech! kilnsales@nyle.com

KilnTech Episode 8: L53/L200 Heat Booster Good Morning Guys, Our very own Stan Krahn is back again to cover some of the basics for our awesome heat booster for our L53 and L200 units! Remember if there is something you would love to see us discuss on an upcoming episode of KilnTech just send a...
Read More

KilnTech Episode 7: L53/L200 Fan Kits Just in time to add them to your Christmas wishlist Stan is here to give you some information on our Awesome fan kits for your next kiln project! Remember if there’s something you'd like to see us talk about in an upcoming episode just send us a message. kilnsales@nyle.com

KilnTech Episode 6: Wet bulb/ Dry bulb placement For Episode 6 of KilnTech, we wanted to address a question that we get a lot. "How do we set up the Wet-bulb/ Dry Bulb system" Give this a watch and let Stan show you how to get started!

KilnTech Episode 5: Wiring the L53 and L200 control boxes You've been asking for it so In this week's episode of KilnTech Stan will be discussing how to wire the control boxes for our L53 and L200 kilns. Let us know what you'd like to see on the next KilnTech! For questions or sales inquiries...
Read More

KilnTech Episode 4: Power Vent Kit In this week's Episode of KilnTech Stan will be going over the installation of our Power vent kit! Check it out and be sure to let us know what else you'd like to see on an upcoming episode of KilnTech!

KilnTech Episode 3: L200M Controls Hey Guys! In this week's episode of KilnTech Stan will be discussing the controls for our L200M series Dehumidification Kilns.