KilnTech Episode 12: Replacing the RTD Sensor Hey guys, We heard you were ready for another episode of KilnTech, so here it is! In this episode of KilnTech, Stan and…
KilnTech Episode 11: L200 Error Message We are pumped to give you another episode of KilnTech! In Episode 11 Stan is going to cover one of the simple error messages…
KilnTech Episode 10: High-Pressure switch reset for L53/L200 Woohoo, it’s our First episode of KilnTech for 2021! In this Episode, Stan will be covering how to reset the High-pressure switch…
KilnTech Episode 9: L53/L200 Drain Line Installation We couldn’t let 2020 end without one more episode of KilnTech. In this episode, Stan discusses how to properly install the drain line…
KilnTech Episode 8: L53/L200 Heat Booster Good Morning Guys, Our very own Stan Krahn is back again to cover some of the basics for our awesome heat booster for our…
KilnTech Episode 7: L53/L200 Fan Kits Just in time to add them to your Christmas wishlist Stan is here to give you some information on our Awesome fan kits for…
KilnTech Episode 5: Wiring the L53 and L200 control boxes You’ve been asking for it so In this week’s episode of KilnTech Stan will be discussing how to wire the…
KilnTech Episode 4: Power Vent Kit In this week’s Episode of KilnTech Stan will be going over the installation of our Power vent kit! Check it out and be sure…
KilnTech Episode 3: L200M Controls Hey Guys! In this week’s episode of KilnTech Stan will be discussing the controls for our L200M series Dehumidification Kilns.
